CA6 Test results
Power derating curve: Representation of the typical variation of nominal resistance (with 95% confidence) throughout the ohm value range:CA6 Through-hole and SMD Damp heat Temperature Coefficient Load life Mechanical life…
Power derating curve: Representation of the typical variation of nominal resistance (with 95% confidence) throughout the ohm value range:CA6 Through-hole and SMD Damp heat Temperature Coefficient Load life Mechanical life…
nominal resistance Test conditions Typical variation of nominal resistance Damp heat 500 h. at 40°C and 95% RH +5%, -2% 500 h. at 40°C and 95% RH ±2% Thermal cycles…
Should the shaft need to be positioned differently than shown on the “models” section on this catalogue, a drawing with the exact position is kindly requested….
Electric Specifications These are standard features; other specifications and out of range values can be studied on request. CA6 Through-hole CA6 SMD Range of resistance values* Lin (A) 100Ω ≤…
materials can be self-extinguishable according to UL 94 V-0 under request. Through-hole and SMD configurations are available. Terminals and collector are normally manufactured in tinned brass, although versions with steel…
detent number 16 (U/Un =100%) to the detent number 1 (U/Un =0%). During the transition between these two detents, the wiper will slide on a dead zone for a few…
95% confidence) throughout the ohm value range:Damp heat CAR14 Through-hole CER14 Through-hole Temperature Coefficient CAR14 Through-hole CER14 Through-hole Load life CAR14 Through-hole CER14 Through-hole Mechanical life CAR14 Through-hole CER14 Through-hole…
between cavities. 750 pcs per reel, 16mmstep between cavities. VSMD.. CY None, only potentiometers. 350 pcs per reel, 20mmstep between cavities. 500 pcs per reel, 20mmstep between cavities. 14003 350…
All models shown here have the most common rotor for 9mm potentiometers: the M rotor. Different rotors are available from the menu above.H2,5 H3,8 HS3,8 H5 HSMD V7,5 V10 V10…
54 (high level of protection against dust and also against water splashing), according to IEC 60529. Plastic materials can be self-extinguishable according to UL 94 V-0 under request. Tapers can…